CAA SRS/ARS - Manual (Page 2)

SRS/ARS INSTALLATION INSTRUCTIONS
www.commandarms.com | 1.866.611.9576 | 215.949.9944
Operation Instructions:
1. Length Extensions Up to 10 Positions
1.1) Loosen the locking bolt (8)
1.2) Press the buttstock extension button (5) .
1.3) Pull the stock lower body (9) backward to the desired postion.
1.4) Optional: You can lock the stock’s length by tightening locking bolt (8) .
2. Cheek Rest Adjustment
2.1) Loosen the two cheek piece adjustment knobs (4) counter clockwise; these knobs hold the cheek rest in
place.
2.2) Raises/Lower the cheek rest (3) to the desired height (up to 9 positions) and tighten the knobs.
2.3) To extend the horizontal cheek rest forward/backward, press the marked areas (10) at the top of the cheek
rest (3) and pull/push to desired length.
2.4 Make sure cheek rest does not interfere with charging handle. (ARS model)
3. Shoulder Pad Height Adjustment
3.1) Loosen should pad adjustment knob (2) lower/raise the shoulder rest pad of the buttstock (1) in the desired
direction and tighten shoulder pad adjustment knob (2) to secure in place.
4. The Use of the Mono Pod
The Mono Pod has 3 operating positions:
• Horizontal position
• 45 degress positon
• Vertical position
Switching between positions is possible by pressing leg position button (11) .
Leg position button (11) postion can be changed from the one site of the SRS to the other side by removing 4 bolts, 2
on each side (12) , switching the button to the other side putting the covers back on and tightening the 4 bolts.
The mono pod leg extension buttons (13 & 14) positions can be changed from the one side of the SRS to the other side
by removing bolt (15) , turning on the mono pod and refitting the bolt (15) .
Mono Pod Operation
Button (14) - Use for quick extension or shortening of the lower extension leg of the mono pod
Button (13) - Use for extension or shortening of the upper extension leg of the mono pod
Turning the mono pod’s knurled ring (16) controls the fine height tuning of the mono pod.