CAA SRS/ARS - Manual

SRS/ARS INSTALLATION INSTRUCTIONS
www.commandarms.com | 1.866.611.9576 | 215.949.9944
1
2
3
4
5
10
6
13
15
8
14
16
11
9
12
7
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Shoulder Rest Pad
Shoulder Rest Adjustment Knob
Cheek Rest
Cheek Rest Adjustment Knobs
Etension Button
Stock Upper Body
Washer (SRS)
Locking Belt
Stock Lower Body
Horizontal Cheek Rest
Leg Position Button
Leg Position Button Bolts
Upper Leg Extension Button
Lower Leg Extension Button
Mono Pod Bolt
Mono Pod Fine Adjustment Ring
WARNING !
Before installing this or any prodict makesure your fire arm is unloaded follow any safey
instructions included with the firearm!
SRS Installation Instructions:
1) Lower the shoulder rest pad (1) by turning the shoulder rest adjustment knob (2) .
2) Raise the cheek rest (3) by partially turning the two cheek rest adjustment knobs (4) counter clockwise; these knobs
hold the rest in place.
3) Loosen the locking bolt (8) and extend the buttstock by pressing button (5) and pulling forward the buttstock upper
body (6)
4) Remove the OEM buttstock from the weapon by unscrewing the bolt located at the rear of the buttstock (save the
bolt!). Slide on the SRS buttstock; tighten SRS using the saved bolt with the SRS washer (7) .
ARS Installation Instructions:
1) Remove the exsisting collapsible stock by pulling down on operating lever and remove stock from buffer tube.
2) Install the 2 supplied metal plates on the buffer tube in the latch pin looking area.
3) Extend the length of pull of the ARS by loosening the locking bolt (8) and pressing the buttstock extensions button (5)
4) Install the ARS stock on the buffer tube. Line up the holes in the picatinny rail on the stock with the holes in the plates.
5) Install the two supplied setscrews through the ARS and into the metal places and tighten with the supplied Allen
wrench.