Bully Dog 52101 Rapid Flow Induction - Manual (Page 4)

3
RAPID FLOW INDuCTION
rEmOvINg ThE STOCk INTAkE
1. Using a flat head screwdriver, loosen the band
clamp that holds the intake tube onto the stock
filter housing. Disconnect the intake tube from
the intake housing.
2. Remove the two screws holding the Mass Air
Flow sensor onto the filter housing outlet us-
ing the special torx bit included in the kit along
with a bit driver. Remove the Mass Air Flow
sensor and put it aside until you are ready to
install it onto the Bully Dog RFI. Be careful
when handling this sensor as it is fragile and
expensive to replace.
3. Using a 10mm socket, remove the nut that holds
the filter housing arm on to the bolt above the
passenger side headlamp. Save the nut, it will
be used to secure the RFI.
4. Remove the stock filter housing from the engine
bay by simply pulling upward on the housing,
the whole assembly will remove in one single
piece.
5. Remove the rubber grommet from the stock air box arm and install it onto the new RFI filter housing.