Bully Dog 52100 Rapid Flow Induction - Manual (Page 5)

RAPID FLOW INDuCTION
INSTALLINg ThE rFI
1. Notice the RFI heat sheild has three holes on the bottom.
Install the rubber grommets/screws taken from the stock
intake box onto the RFI heat sheild.
2. Set the RFI filter housing into the engine bay. Line up the
threaded posts on the coming upward from the fender well
to the screw holes on the intake sheild. Secure the intake
sheild by tightening the screws installed on the RFI to the
threaded posts.
3. Connect the intake hose over the RFI Outlet Secure the con-
nection using a flat head screwdriver.
4. Place the air filter onto the outlet tube on inside of the in-
take heat sheild. Secure the filter using a flat head screw
driver to tighten the provided band clamp around the end
of the filter.