Bully Dog 52100 Rapid Flow Induction - Manual (Page 4)

3
RAPID FLOW INDuCTION
rEmOvINg ThE STOCk INTAkE
1. Using a screwdriver, loosen the band clamp that holds the
intake tube onto the stock filter housing. Disconnect the
intake tube from the intake housing.
2. Remove the lid of the stock intake housing by unsnapping
the clips that hold the lid in place. Also remove the stock
filter pannel.
3. Notice the three screws at the bottom of the stock, these
three screws are what secure the intake box to the vehicle.
Unscrew the three screws using your hands, if they are to
tight use pliers to initially loosen. After all of the grommets
are loosened remove the bottom part of the intake from the
vehicle.
4. Remove the rubber grommets from the stock air box, with
the screws still attached to the grommets, they will need to
be installed on the Bully Dog RFI.