Bully Dog 82224 Rapid Flow - Manual (Page 5)

6
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 82224
Important: It is illegal in all 50 states and Canada to remove the catalytic converter.
REMOVAL OF STOCk EXHAUST SySTEM
In these steps you will remove the stock exhaust system.
1.Use a sawzall to cut the
exhaust directly behind the
muffler.
2. Cut the Straight Pipe in front of the muffler.
3. Cut the stock Down Pipe
just after the bend.
4. Loosen the stock band
clamp using a 7/16” deep socket where the
stock down pipe is connected to the turbo.
The stock band clamp will be used later so
don’t remove it, just
loosen it enough to re-
move the stock down
pipe.
5. To make removing the Hangers an easier
process it is recommended that you use a
silicone spray lubricant to spray each of the
rubber hangers holding the stock exhaust.
6. Remove each piece of the stock exhaust system, including
the stock exhaust hangers.
Cut directly behind the Muffler
Cut 4” behind Catalytic Converter
Remove all the necessary exhaust hangers
7/16”