Bully Dog 82410 Rapid Flow - Manual (Page 9)

10
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 82410
8. At this point it is time to install the Straight
Pipe (s). You will need to measure and cut
the Straight Pipe (s) for the final fit. Keep
in mind when you make your final cut you
will need to leave an extra 3 inches of over-
lap when you cut the Straight Pipe.
Don’t cut the flared end.
9. Once the entire exhaust system is installed,
inspect the system to ensure that no part
of the exhaust is in direct contact with the
chassis or body; adjustments may be neces-
sary.
10. Return to each of the Clamps and
tighten with a 9/16” wrench. Do not
over tighten the Clamps.
Measure for Straight Pipe
Complete System Installed
3”
9/16”