Bully Dog 83200 Rapid Flow - Manual (Page 9)

10
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 83010,83200
11. At this point if you need the extra
Straight Pipe cut the Straight Pipe to
the desired length. Keep in mind that
you need 3 inches of overlap when
you cut the pipe. If you don’t need the
Straight Pipe simply install the Muffler
directly into the Cross Member section.
If the Straight Pipe is not needed, you
will have an extra Straight Pipe and
an extra clamp left over when you are
finished.
12. Once the entire exhaust system
is installed, inspect the system to
ensure that no part of the exhaust is
in direct contact with the chassis or
body; adjustments may be necessary.
Having any part of the exhaust sys-
tem in direct contact with any part of
the body or chassis will the cause the
exhaust to rattle.
Measure Straight Pipe
Muffler
3”
Complete System Installed
13. Return to each of the Clamps and tighten with a 9/16” wrench. Again do not over tighten
Clamps. 9/16”