Bully Dog 51105 Rapid Flow Induction (RFI) Cold Air Intake - Manual (Page 5)

4
Parts Description:
This section describes each part and any special features of each part that need to be noted
to assist with installation. All parts will be referred to during installation by the names used
in this section.
The RFI base: The base to the enclo-
sure that holds the filter has a couple of
features to note. The first is the circular
hole on the back of the base, this hole is
where the RFI tube will snap into the base
and hold secure the air filter. The second
important part of the base to take special
notice of are the mounting pegs that are
located on the bottom of the filter hous-
ing base. The mounting pegs are used to
secure the base to the mounting plate
within the engine bay.
The RFI Lid: The lid is very easy to re-
move for filter maintenance, be aware
that the tongue and grove formed
between the housing base and the
lid needs to be properly lined up for
a good seal. The latch mounts on
the lid should always match up
Parts Description