Bully Dog 53108 Rapid Flow Induction (RFI) Cold Air Intake - Manual (Page 4)

5 6
RFI COLD AIR INTAKE RFI COLD AIR INTAKE
2. Release the locking tab and unplug mass air flow sensor.
3. Release the locking tab and unplug temperature sensor
which is located on the backside of the box.
4. Use a flat-head screwdriver to loosen the band clamps
located at each end of the stock intake tube. You do not
need to completely disconnect the clamps, just loosen them
enough to remove the tube.
Installation
Installation is very simple, and
can be separated into three
parts: Removing the Stock
Intake, Preparing the Bully
Dog RFI Intake and Installing
the Bully Dog RFI Intake. The
complete installation of the
RFI Cold Air Intake system
should take about 20 minutes.
The assembly diagram below
shows how the parts of the
intake fit together in sequence.
Removing the Stock Intake
1. IMPORTANT
Before beginning installation,
disconnect your battery at the
negative terminal. Failure to
disconnect the battery could
result in personal injury and/or
damage to your vehicle.