Bully Dog 53252 Rapid Flow Induction (RFI) Cold Air Intake - Manual (Page 9)

8
6. The stock filter housing is connected to a plate that sits beneath it by some rubber grom-
mets. It can be easily removed by simple pulling up on the end of the tube. Remove the
enclosure along with the MAF sensor tube.
7. The last step in removing the stock intake is to remove the intake plate that sat below the
stock filter housing and held the filter housing in place. A 10mm socket with a ratchet are
the best tools to use. A 12” extension is recommended to make the job easier.
Stock Removal
Three of the four bolts removed from
the intake plate will be used during the
installation of the Stage 2 Rapid Flow
intake.
Pull upward on the entive enclosure and it will all
come out as one piece.