Bully Dog 182062 Dodge 5.9L Cummins 2500-3500 04.5-07 - Manual (Page 7)

rAPid FlOW inSTAllATiOn
INSTALLATION OF THE BULLY DOG RAPID FLOW EXHAUST SYSTEM
Important: Do not over-tighten Clamps. too much torque will result in deformation of the exhaust. For best results
when doing the installation, tighten the Clamps enough to hold the exhaust pieces in place, but don’t tighten down until
the entire exhaust system is installed.
1. It is suggested that before installing the sys-
tem on the truck, the Rapid Flow Exhaust
System be laid out on a large flat surface to
acknowledge the location of each piece.
2. Hang each of the hangers. Hangers A & B
will serve dual purposes as both hangers
and clamps. Hanger A will be at the front of
the muffler and Hanger B will be at the rear.
Hanger C will hold the tail pipe tip.
3. Install the Adapter at the back of Catalytic
Converter.
Hanger B
Hanger C
6
Hanger A
Hang the Hangers
Hanger B
Hanger A
Install Adapter
Adapter
Stock Catalytic Conveter