beautypg.com

Uninstalling - returning to stock, What does this mean, When to return to stock – Bully Dog 40410 50 State Legal GT Gas User Manual

Page 36

background image

40410

50 S

ta

te GT G

as

35

unInSTALLInG - ReTuRnInG To SToCk

What does this mean?

“Uninstalling the tune” and “returning to stock” are different ways to describe the same thing: writing the original (stock)
information to the engine computer so it uses the settings that it used before you installed your GT. Doing this also sends a
signal to the GT to let it know that it is no longer installed on a vehicle, which will allow you to install the tune at a later time.
The GT will not allow you to install if the tune has already been installed on a vehicle.

When to Return to Stock

You should return to stock in ALL of the following situations:

• EVERY TIME you take your vehicle in for any type of service. It is a very common practice for the engine computer to be “flashed” (re-

programmed) during all types of service, even routine maintenance. If the tune from the GT still installed when the engine computer is
flashed, it can cause problems when you want to use your GT in the future. See page 37 for more information.

• If you want to install the GT on a different vehicle. For instance

If you have a second vehicle and want to try the GT on it. The GT can only be used on one vehicle at a time.
If you want to let a friend try the GT.
If you have decided to sell the GT to someone else.

• If the battery is having problems and could possibly go dead. Make sure to connect a battery charger while returning to stock to prevent

any complications that can be caused by interrupting the GT while it is returning your vehicle to stock. See page 31 for more informa-
tion.

• If you need to disconnect the battery for any reason.

IMPORTANT NOTE: If you do not return your vehicle to stock, you may have to call in to technical support to have your GT reset. There is a mandatory fee for this

service. See pages 39 and 47 for more information about the reset fee and contacting technical support.