Bully Dog 40630 CAT 3126, C7 and C9 engines - Manual (Page 6)

5
4. Plug the male OEM MAP sensor plug into
the female Module MAP sensor plug.
5. Plug the female OEM MAP sensor plug in
the male Module MAP sensor plug.
6. Locate the ICP Sensor: like with the MAP sensor plug,
locate the ICP sensor and then follow the connected
wire harness to the plug set and disconnect that plug
set in preparation to tie in the Bully Dog harness. The
Injection Control Pressure sensor is located on the right
side of the engine near the front.
MAP w/ Rapid Power connected
inSTAllATiOn
Injection Control Pressure Sensor
Injection Control Pressure Sensor
Plug Set
L R
F B