brite-View Air SyncHD BV-2322 User Manual User Manual
Page 17
16
(4)
If it is on Standby mode with the loop-through connection on, and the 1
nd
display attached to
the transmitter + A/V source is on (Transmitter POWER LED is lit in purple and Receiver POWER
LED is lit in red), press the POWER button of receiver to turn on the BV-2322T and BV-2322R.
Note :
During this period, BV-2322T will enter Standby mode and turn off Loop-through output
when press the POWER button of transmitter or press the POWER key of RCU pointed at
transmitter.
(5)
During the warm-up, the POWER LED will blink in blue until the signal link between the
BV-2322T and the BV-2322R is established.
Ensure your2
nd
TV set or projector is on “HDMI input” mode, and is already powered on.