Blizzard Lighting ProKontrol MH(Rev A) - Manual (Page 12)

Page 12
ProKontrol MH Manual Rev. A © 2013 Blizzard Lighting, LLC
3.5.6 RDM DMX Address Setup
1. Press and hold for 2 seconds to enter Menu Mode.
2. Rotate the PAN wheel to locate “05. RDM DMX Address setup”.
3. Press to confirm.
4. Rotate the PAN wheel to select YES or NO; If YES and you press
you will enter RDM operation.
5. The ProKontrol™ MH will search and show the number of RDM
devices.
6. Rotate the PAN wheel to select an RDM device; rotate the TILT wheel
to adjust the DMX address of the RDM device. Press to
confirm.
7. Press to switch the information of the selected device,
Press to verify the selected device.
8. Press to return to the main men
3.6 Manual Fixture Control
1. Press the button to activate FIXTURE mode.
2. Select the desired fixtures with the number buttons (1-16) and the
PAGE button (PAGE A: 1-16, PAGE B: 17-32).
3. Move the faders and/or wheels to adjust the DMX output values. In
Step 2, fixtures can be selected one by one; Alternatively, you can
select more fixtures in a single operation. For example, to select
Fixture 1-8, you can press and hold the number button 1 and then
press the number button 8, Fixture 1-8 will all be selected. The same
can be applied to deselect fixtures.
3.7 Fade Mode
1. Press and hold for 2 seconds to enter Menu Mode.
2. Rotate the PAN wheel to locate “04. Fade mode”.
3. Press to confirm.
4. Rotate the PAN wheel to select ALL CHANNEL or ONLY PAN/TILT.
5. Press to confirm or to return to the main menu.
3.8 Built-In Movement and Color Effects
There are 9 built-in “movements” in the ProKontrol™ MH, and 7 built-in color
macros for LED fixtures. Before running a movement, all fixtures must be
patched correctly.
1. Press the button to enter FIXTURE mode (indicator on).
2. Select the desired fixtures with the number buttons (1-16) and the
PAGE button (PAGE A: 1-16, PAGE B: 17-32).
3. Press the button to activate the MOVEMENT mode.
4. Select a desired MOVEMENT/MACRO with the number buttons (1-16).
5. Movement 1-9 is for the pan/tilt movement of moving heads. By
using the button, toggle through the options.