Blizzard Lighting ProKontrol MH(Rev A) - Manual (Page 11)

Page 11
ProKontrol MH Manual Rev. A © 2013 Blizzard Lighting, LLC
3.5 System Functions
3.5.1 Resetting The System
WARNING: This will reset the controller to its factory defaults. ALL PROGRAMS AND
SETTINGS WILL BE ERASED!
1. Press and hold for 2 seconds to enter Menu Mode.
2. Rotate the PAN wheel to locate “02. Reset factory”.
3. Press to confirm.
4. Rotate the PAN wheel to select YES or NO.
5. Press to confirm or to return to the main menu.
3.5.2 Delete All Fixture Patches
1. Press and hold for 2 seconds to enter Menu Mode.
2. Rotate the PAN wheel to locate “03. delete all Fixture patch”.
3. Press to confirm.
4. Rotate the PAN wheel to select YES or NO.
5. Press to confirm or to return to the main menu.
3.5.3 Data Back-Up to USB Memory Stick
1. Press and hold for 2 seconds to enter Menu Mode.
2. Rotate the PAN wheel to locate “06. Data back up”.
3. Press to confirm.
4. Insert a USB memory stick to the USB port.
5. Rotate the PAN wheel to select YES or NO; press to confirm.
6. Press a number button to store the back-up file. Up to 16 files can be
backed up, respectively stored in number 1-16 buttons. If the LED indicator
of a number button is on, it means there is back-up file in this position.
7. Press the button to return to the main menu.
3.5.4 Load Data From USB Memory Stick
1. Press and hold for 2 seconds to enter Menu Mode.
2. Rotate the PAN wheel to locate “07. data load.”
3. Press to confirm.
4. Make sure your USB memory stick is in the USB port.
5. Rotate the PAN wheel to select YES or NO; press to confirm.
6. Press a number button to load the back-up file. Up to 16 files can be
backed up, respectively stored in number 1-16 buttons. If the LED indicator
of a number button is on, it means there is back-up file in this position.
7. Press the button to return to the main menu.
3.5.5 Send Fixture Update File (RDM Fixtures Only)
Through the DMX cable, send fixture firmware code.
1. Press and hold for 2 seconds to enter Menu Mode.
2. Insert a USB memory stick to the USB port.
3. Rotate the PAN wheel to locate “08. Send fixture Update file”.
4. Press to confirm.
5. Rotate the PAN wheel to locate the file to send.
6. Press to start sending.
7. Repeat Step 4 and 5 to send another file.
8. Press the button to exit.