Blizzard Lighting Kontrol 5(Rev. A) - Manual (Page 9)

KONTROL 5 Manual Rev A.
Page 9
© 2012-13 Blizzard Lighting, LLC.
ALL RIGHTS RESERVED
3.1.4 Resetting The System
WARNING: This will reset the controller to its factory defaults. ALL PRO-
GRAMS AND SETTINGS WILL BE ERASED!
1. Turn the unit off.
2. Press and hold , &
3. Turn the unit on while you continue to hold &
CLEAR>
4. All LEDs will blink. Release the held buttons and the LEDs will stop
blinking.
5. The settings will be reset to factory defaults.
3.2 Programming
Regardless of whether you are programming a chase or scene, you must first
enter programming mode.
3.2.1 Entering Programming Mode
1. Press and hold for 3 seconds.
2. The Program/REC LED indicator will blink, indicating programming is
active.
3. The LED indicators for any previously programmed scenes in the cur-
rent bank and any previously programmed chases will blink.
4. Programming mode is now active.
3.3 Color/Scene Preset Programming Mode
This allows the user to create a preset color/scene which can be used to
override current fixture output and may also be used in chase programming.
3.3.1 Creating A New Color/Scene Preset
1. Enter programming mode as described in Section 3.2.1.
2. Using the button(s), select the fixtures to
include in the Color/Scene Preset.
3. Adjust the fixture(s) output using as
desired.
4. Press .
5. Select the desired scene page using .
6. Press . All LEDs will flash quickly.
7. Repeat steps 1-6 to add additional presets if desired.
8. Hold for 3 seconds to exit programming mode. The
LED indicator above the button will extinguish.
3.3.2 Color/Scene Preset Delete Mode
This allows the user to delete a previously programmed preset color/scene.
1. Enter programming mode as described in Section 3.2.1.
2. Select the desired scene bank using .
3. Hold , then press the button you wish
to delete.