Blizzard Lighting Kontrol 5(Rev. A) - Manual (Page 13)

KONTROL 5 Manual Rev A.
Page 13
© 2012-13 Blizzard Lighting, LLC.
ALL RIGHTS RESERVED
2. Press the button until the LED indicator for MANUAL
mode is illuminated.
3. Using the buttons, move through the steps in the
selected chase.
3.5.4 Playback Override
Allows the user to manually override the current output while in Color/Scene
Preset or Chase Playback Mode.
1. Ensure that BLACKOUT mode is not selected, IE that the LED indica-
tor above the button is not lit.
2. Using the button(s), select the fixtures to
be controlled.
3. Adjust the color output using as desired.
4. To return to Color/Scene Preset or Chase Playback Mode, press
.
3.5.5.1 Strobe Setup
Allows the user to set the channel/channels which will be controlled by the
strobe function, for each fixture.
1. Enter programming mode as described in Section 3.2.1.
2. Press the button.
3. Using the button(s), select the fixtures to
setup.
4. Using the buttons, select the channel to adjust.
5. To enable the strobe function on the channel selected, press the
button.
6. To disable the strobe function on the channel selected, press
CLEAR>.
7. Repeat steps 2-7 to adjust additional channels/fixtures as desired.
8. Hold for 3 seconds to exit programming mode. The
LED indicator above the button will extinguish.
3.5.5.2 Strobe Playback
Allows the user to strobe the current playback. Note: Strobe operates even
when the button is active.
1. Press and hold the button. All currently selected/operat-
ing fixtures will strobe.
2. Using the fader, adjust the strobe speed, from 1
to 20 flashes per second.
3. Release the button, and strobing will stop.
3.5.6 Blackout
Allows the user to stop all fixture output immediately (except while strobing
is active).
1. Press the button. All output will cease. The LED
indicator will illuminate.
2. Press the button again, and playback will resume