Getting started, 1 what’s in the box, 2 getting it out of the box – Blizzard Lighting Kontrol 5(Rev. A) User Manual

Page 3: 3 powering up, 4 getting a hold of us, Getting, Started 3, What’s, Powering

KONTROL 5 Manual Rev A.

Page 3

1. GETTING STARTED

1.1 What’s In The Box?

•

1x KONTROL 5™ DMX Controller

•

1x 9VDC, 300ma (minimum) AC/DC Adaptor

•

A Warranty Card & Warranty Info

•

This Lovely User Manual

1.2 Getting It Out Of The Box

We could tell just by lookin’ atcha. You’re a bit of a control freak, aren’t

ya? Just kidding! CONGRATULATIONS! You’ve purchased a GREAT little

DMX controller! Bravo! Now that you’ve got your KONTROL 5™, you

should carefully unpack the box and check the contents to ensure that all

parts are present and in good condition. If anything looks as if it has been

damaged in transit, notify the shipper immediately and keep the packing

material for inspection. Again, please save the carton and all packing ma-

terials. If a fixture must be returned to the factory, it is important that the

fixture be returned in the original factory box and packing.

1.3 Powering Up!

All fixtures must be powered directly off a switched circuit and can-

not be run off a rheostat (variable resistor) or dimmer circuit, even

if the rheostat or dimmer channel is used solely for a 0% to 100%

switch.

AC Voltage Switch - Not all fixtures have a voltage select switch, so please

verify that the fixture you receive is suitable for your local power supply.

See the label on the fixture or refer to the fixture’s specifications chart for

more information. A fixture’s listed current rating is its average current

draw under normal conditions. Check the fixture or device carefully to

make sure that if a voltage selection switch exists that it is set to the cor-

rect line voltage you will use.

Warning! Verify that the voltage select switch on your unit matches

the line voltage applied. Damage to your fixture may result if the

line voltage applied does not match the voltage indicated on the

voltage selector switch. All fixtures must be connected to circuits

with a suitable Ground (Earthing).

1.4 Getting A Hold Of Us

If something is wrong, just give us a call or send an email. We’ll be happy

to help, honest.

Blizzard Lighting

W220 N1531 Jericho Ct. Suite E, Waukesha, WI 53186 USA

[email protected] | Phone: 866-493-6025