Blizzard Lighting Kontrol 6(Rev. A) User Manual

Page 10

KONTROL 6 Manual Rev B.

Page 10

4. All LEDs will flash 3 times, and the LED indicator for the selected

scene will now remain off. The scene has been deleted.

5. Repeat steps 2-4 to delete additional presets if desired.

6. Hold for 3 seconds to exit programming mode. The

LED indicator above the button will extinguish.

3.4 Chase Programming

A chase is a sequence of different scenes or steps which are called one after

another. KONTROL 6 can store up to 18 programs of 200 scenes each.

3.4.1 Creating A New Chase

1. Enter programming mode as described in Section 3.2.1.

2. Using the button, select the chase you wish to pro-

gram.

3. Using the button(s), select the fixtures to

include in the chase step.

4. Adjust the fixture(s) output using as de-

sired, OR, to use a previously programmed scene/color preset:

5. Select the desired scene bank using .

6. Press .

7. Press . All LEDs will blink 3 times to indicate the first

step has been stored successfully.

8. Repeat steps 2-6 to store additional steps if desired. Up to 200 steps

may be stored in each chase. If 200 steps have been stored in a

chase and the user attempts to store an additional step, the LED

display will read FULL.

9. Hold for 3 seconds to exit programming mode. The

LED indicator above the button will extinguish.

NOTE: After scene programming, press the button to clear

any output, to avoid inadvertently overwriting a scene/color preset.

3.4.2 Inserting a Chase Step

1. Enter programming mode as described in Section 3.2.1.

2. Using the button, select the chase you wish to modify.

3. Press the button. The LED indicator will illuminate

and the current step will display on the LED display. If there are no

steps in the chase, the display will read ST00.

4. Use the buttons to select the position for the in-

serted step.

5. Using the button(s), select the fixtures to

include in the chase step.

6. Adjust the fixture(s) output using as de-

sired, OR, to use a previously programmed scene/color preset:

7. Select the desired scene bank using .

8. Press .

9. Press . All LEDs will blink 3 times to indicate the first

step has been stored successfully. If no data has been stored, the

LED display will read NULL.

10. Repeat steps 2-9 to store additional steps if desired. Up to 32 steps

may be stored in each chase. If 32 steps have been stored in a chase

and the user attempts to store an additional step, the LED display will