Blizzard Lighting The Puck Fab 5 Skywire (Rev A) - Manual (Page 3)

Page 3
The Puck™ Fab5 Skywire Manual Rev. A Copyright (c) 2013 Blizzard Lighting, LLC
1. GETTING STARTED
What’s In The Box?
• 1 x Puck™ Fab5 Skywire Flat LED PAR Fixture
• 1x IEC Power Cord
• This Lovely User Manual
Getting It Out Of The Box
Congratulations on purchasing one of the coolest flat LED PAR cans on the market today!
Based on our fantastic Puck™ design, THEN adding built-in Skywire™ wireless DMX, AND
our proprietary ultra long-life intelion™ Lithium-Ion Battery System give you a fixture with
TONS of output, flexibility and fantastic battery-powered run time.
Now that you’ve got the Puck™ Fab5 Skywire (or hopefully, Puck Fab5 Skywire’s!), you
should carefully unpack the box and check the contents to ensure that all parts are pres-
ent and in good condition. If anything looks as if it has been damaged in transit, notify the
shipper immediately and keep the packing material for inspection. Again, please save the
carton and all packing materials. If a fixture must be returned to the factory, it is impor-
tant that the fixture be returned in the original factory box and packing.
Powering Up!
All fixtures must be powered directly off a switched circuit and cannot be run off a
rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer
channel is used solely for a 0% to 100% switch.
AC Voltage Switch - Not all fixtures have a voltage select switch, so please verify that the
fixture you receive is suitable for your local power supply. See the label on the fixture or
refer to the fixture’s specifications chart for more information. A fixture’s listed current
rating is its average current draw under normal conditions. Check the fixture or device
carefully to make sure that if a voltage selection switch exists that it is set to the correct
line voltage you will use.
Warning! Verify that the voltage select switch on your unit matches the line
voltage applied. Damage to your fixture may result if the line voltage applied
does not match the voltage indicated on the voltage selector switch. All fixtures
must be connected to circuits with a suitable Ground (Earthing).
Getting A Hold Of Us
If something is wrong, just give us a call or send an email. We’ll be happy to
help, honest.
Blizzard Lighting
N16 W23390 Stoneridge Dr. Ste E
Waukesha, WI 53188 USA
www.blizzardlighting.com
414-395-8365
Email: [email protected]
Disclaimer: The information and specifications contained in this document are subject to change
without notice. Blizzard Lighting™ assumes no responsibility or liability for any errors or omissions that
may appear in this user manual. Blizzard Lighting™ reserves the right to update the existing document
or to create a new document to correct any errors or omissions at any time. You can download the
latest version of this document from www.blizzardlighting.com.
Author: Date: Last Edited: Date:
J. Thomas 6/27/2013 J. Thomas 7/19/2013