Blizzard Lighting Micro SwitchBlade - Manual (Page 16)

Page 16
SwitchBlade™ Micro User Manual Rev. A (c) Copyright 2014 Blizzard Lighting, LLC
DMX Values In-Depth (11-Channel Mode)
Channel Value What It Does
1 000 <--> 255 Pan (0-540°)
2 000 <--> 255 Tilt (0-270°)
3 000 <--> 255 Fine Pan (fast <--> slow)
4 000 <--> 255 Fine Tilt (fast <--> slow)
5 000 <--> 255 Pan/Tilt Speed (slow <--> fast)
6 000 <--> 255 Dimmer (0% <--> 100%)
7 000 <--> 255 Strobe (slow <--> fast)
8 000 <--> 255 Red Intensity (0% <--> 100%)
9 000 <--> 255 Green Intensity (0% <--> 100%)
10 000 <--> 255 Blue Intensity (0% <--> 100%)
11 000 <--> 255 White Intensity (0% <--> 100%)
Troubleshooting
Symptom Solution
Fixture Auto-
Shut Off
Check the fan in the fixture. If it is stopped or moving
slower than normal, the unit may have shut itself off due to
high heat. This is to protect the fixture from overheating.
Clear the fan of obstructions, or return the unit for service.
Beam is Dim Check optical system and clean excess dust/grime. Also
ensure that the 220V/110V switch is in the correct position,
if applicable.
No Light Out-
put
Check to ensure fixture is operating under correct mode, IE
sound active/auto/DMX/Etc., if applicable. Contact service
for more information.
Chase Speed
Too Fast/Slow
Check to ensure proper setup of speed adjustment.
No Power Check fuse, AC cord and circuit for malfunction.
No Response
to Audio
Verify that the fixture is in “Sound Active” mode.
Adjust Audio Sensitivity, If Applicable.
Fixture Not
Responding /
Responding
Erratically
Make sure all connectors are seated properly and securely.
Use Only DMX Cables.
Install a Terminator.
Check all cables for defects.
Reset fixture(s).
If your problem isn’t listed, or if problems persist,
please contact support: [email protected].