Blizzard Lighting RGBW LED Strip StormChaser (Rev C) - Manual (Page 13)

Page 13
StormChaser Manual Rev. C Copyright (c) 2012 Blizzard Lighting, LLC
DMX Values In-Depth (7/10/31 Channel Mode)
Channel Channel Value 7 Channel 10 Channel 31 Channel
1
000 <-> 010
011 <-> 042
043 <-> 084
085 <-> 127
128 <-> 191
192 <-> 255
Mode
No Function
7 Channel Mode
31 Channel Mode
10 Channel Mode
2 Channel Mode
Sound Active Mode
2 000 <-> 255 Dimmer (0 <-> 100%)
3 000
001 <-> 255
Strobe
No Function
Strobe (Slow <-> Fast)
4 000 <-> 255 Global Red Intensity Pixel 1 Global Intensity Pixel 1 Red Intensity
5 000 <-> 255 Global Green Intensity Pixel 2 Global Intensity Pixel 1 Green Intensity
6 000 <-> 255 Global Blue Intensity Pixel 3 Global Intensity Pixel 1 Blue Intensity
7 000 <-> 255 Global White Intensity Pixel 4 Global Intensity Pixel 1 White Intensity
8 000 <-> 255 N/A Pixel 5 Global Intensity Pixel 2 Red Intensity
9 000 <-> 255 N/A Pixel 6 Global Intensity Pixel 2 Green Intensity
10 000 <-> 255 N/A Pixel 7 Global Intensity Pixel 2 Blue Intensity
11 000 <-> 255 N/A N/A Pixel 2 White Intensity
... ... ... ... ...
28 000 <-> 255 N/A N/A Pixel 7 Red Intensity
29 000 <-> 255 N/A N/A Pixel 7 Green Intensity
30 000 <-> 255 N/A N/A Pixel 7 Blue Intensity
31 000 <-> 255 N/A N/A Pixel 7 White Intensity
Troubleshooting
Symptom Solution
Beam is Dim Check optical system and clean excess dust/grime. Also ensure that the
220V/110V switch is in the correct position, if applicable.
No Light Output Check to ensure fixture is operating under correct mode, IE sound active/auto/
DMX/Etc., if applicable. Contact service for more information.
Chase Too Fast/Slow Check to ensure proper setup of speed adjustment.
No Power Check fuse, AC cord and circuit for malfunction.
Blown Fuse Check AC cord and circuit for damage, verify that moving parts are not re-
stricted and that unit’s ventilation is not obstructed
Slow Movement Verify that 220V/110V switch is in the correct position, if applicable. Also check
that speed channels are set appropriately.
No Response to Audio Verify that the fixture is in “Sound Active” mode.
Adjust Audio Sensitivity, If Applicable.
Fixture Not Responding /
Responding Erratically
Make sure all connectors are seated properly and securely.
Use Only DMX Cables.
Install a Terminator.
Check all cables for defects.
Reset fixture(s).
Fixture Moving On Its
Own
Verify proper mode of operation. Is the fixture in “Auto” mode?
If your problem isn’t listed, or if problems persist, please
contact support: [email protected].