Dmx address: 001, Run program: 01-19, Slave mode – Blizzard Lighting COBZilla COB RGB 5X5 Pixel Matrix User Manual

Page 13: Sound trigger, Sensitivity 00-31, Static color, Page 13

Page 13

CobZilla™ COB RGB 5X5 Pixel Matrix Manual Rev. A

DMX Mode

Allows the unit to be controlled by any universal DMX controller. If you are unfamiliar with

DMX, please read the DMX Primer on page #16.

The COBZilla™ COB RGB 5X5 Pixel Matrix is capable of operating

with 3, 5, or 75 DMX channels. To select the channel mode that you desire,

1:) Press the button to select

DMX address: 001

on the LED

Readout.

2:)

Then press the button to select channel mode,

channels: 03, 05, 75 CHs

. Use the or to select desired channel.

Auto, Master/Slave, Sound Active & Static Color Modes:

Allows a single or Master/Slaved units to run factory installed programs at user selectable

speeds.

1.) To set the fixture to one of the Built-in Programs,

select

RUN PROGRAM: 01-19

using the button. Select desired

program by using the and buttons

2.) To set the program and Strobe setting, select

SP: 001-100 FS: 000-100

using the button then the and buttons to

choose desired program/strobe function. Press the button to

switch between settings.

3:) To use Auto Mode, Press the button to reach

AUTO times: 001-100.

Use the and buttons

to choose desired program

4:) To set the program speed and Strobe setting,

select

SP: 001-100 FS: 000-100

using the button then the

and buttons to choose desired program/strobe function.

Press the button to switch between settings.

Master/Slave Mode:

1:) Each fixture is a master by default. To set the fixture as a slave, use the

button to reach

SLAVE MODE

======================

2.) Press the button to exit out of the menu.

Sound Active Mode:

1.) To use sound active mode, select

SOUND TRIGGER

by pressing .

2.) Press the button to change the

sensitivity 00-31

by using the

and buttons.

3.) Press the button to exit sound trigger mode.

Color Static Mode:

1.) Press the button to reach

STATIC COLOR

2:) Then press the button to set the color

R255 G255 B255.

By using the and buttons, this allows you to

change each value. (000-255)

3.) Press the button to exit static color mode.