Bird Technologies 4421-250 - Manual (Page 4)

Instructions
l
Remove (4) button Head Screws. A
l
Move Front Panel B away from Bezel. F
l
Disconnect Ribbon Cable C and Hex Nut, L’Washer and Green
Ground Wire. D
l
Remove Front Panel B , remove (4) Phillips Head Screws E , remove
Bezel. F
l
Align (4) Mounting Holes in Rack Panel G to (4) Mounting Holes in
Bezel. F
l
Using the (4) Phillips Head Screws E , attach Rack Panel G and
Bezel F to the original Mounting Holes in Frame.
l
Reverse remainder of procedure for Reassembly.
l
After Reassembly of Front Panel is completed, connect Interface Cable
H to Rear of unit.
l
Connect Opposite End to Connector Box on Rack Panel. G
l
Removal of Handle M :
l
Remove (2) Buttons. I
l
Remainder of Hardware and Handle J thru Q can now be
removed.
l
Place Interface Cable H in Handle slot as indicated on drawing (See
Notes 1 and 2).
2