Bird Technologies 7000A545 - Manual (Page 4)

Bird Technologies
2
Instructions
1. Connect the adapter to the test port on the Antenna Tester.
2. Connect the mismatch to the adapter.
3. Press the ON key.
4. Press the MENU key.
5. Press the MEAS MATCH key.
6. Press the SINGLE FREQ key.
7. Press the UNITS key.
8. Press the RHO key.
9. Press the FREQ MHz key.
10. Using the numeric keys, enter the frequency for the first data point as docu-
mented in the test data for the mis-match.
11. Press the ENTER key.
12. Compare the resultant value to the minimum and maximum values listed for
the frequency entered in Step 10.
13. Repeat Step 10 through Step 12 for each frequency point listed in the mis-
match test data sheet. To enter another frequency repeatedly press the
SELECT key until the cursor is blinking on the frequency, then use the
numeric keys to enter the desired frequency.
14. If any value is outside the listed minimum and maximum acceptable values
see the Calibration section on page 3.