Burnham LEDV SERIES - Manual (Page 4)

4
NOTICE
All boilers must be installed in accordance with National, State and Local Plumbing, Heating
and Electrical C odes and the regulations of the serving utilities which may differ from this
manual. Authorities having jurisdiction should be consulted before installations are made.
In all cases, reference should be made to the following Standards:
A.
B.
C.
USA BOILERS
C urrent Edition of American National Standard ANSI/NFPA 31, “Installation of Oil Burning
Equipment” , for recommended installation practices.
Current Edition of American National Standard A NSI/NFPA 211, “Chimneys, Fireplaces,
Vents, and Solid Fuel Burning Appliances”, For Venting requirements.
C urrent Edition of American Society of Mechanical Engineers ASME CSD-1, "Controls and
Safety D evices for Automatically Fired Boilers", for assembly and operations of controls
and safety devices.
CA NAD IAN BOILERS
A. Current Edition of C anadian Standards Association CSA B139, "Installation C ode for Oil
B urning Equipment", for recommended Installation Practices.
This boiler is suitable for installation on combustible flooring. Boiler cannot be installed on
carpeting.
F o r o p ti mu m p e r f o rm a n c e a nd s e rv i c e a b ilit y f r om th is u nit a dh e r e t o t h e f o ll o w in g
recommendations:
A.
B.
C.
D.
E.
D o not tamper w ith or alter the unit or controls. Retain your contractor or a competent
serviceman to assure that the unit is properly adjusted and maintained.
C lean firetubes at least once a year - preferably at the start of the heating season to remove
soot and scale. Inside of C ombustion Chamber should also be cleaned at the same time.
Have Oil Burner and Controls checked at least once a year or as may be necessitated.
Do not operate unit w ith jumpered or absent controls or devices.
Do not operate unit if any control, sw itch, component, or device has been subject to w ater.