Bendix Commercial Vehicle Systems BLINDSPOTTER INSTALLATION GUIDE - Manual (Page 9)

7
System Operation
Side Object Detection Display
The display unit has two bright LED indicators used to display the system status. A
yellow LED indicates when the system is active, and a red LED indicates an object
is detected. An ambient light sensor automatically controls the intensity of the two
status LEDs, dimming them in low light conditions.
The display unit's built-in speaker provides an audible alert if an object is detected
when the vehicle's turn signal is activated. A button located on the front of the
display allows the driver to adjust the volume level.
System Failure
If the system detects a failure and becomes inoperative, the display unit will warn
the driver by continuously illuminating both the red and yellow LEDs at the same
time.
Refer to the troubleshooting section for more information about system failure.
Volume Control Button
Red Object Detected Indicator
Ambient Light Sensor
Yellow Power / Standby Indicator