Bausch & Lomb Boston Multivision GP Contact Lenses - Manual (Page 5)

• To store lenses, disinfect and leave them in the closed/unopened case until ready to wear. If lenses are not
to be used immediately following disinfection, the patient should be instructed to consult the Package Insert
or the eyecare practitioner for information on storage of lenses .
• After removing the lenses from the lens case, empty and rinse the lens storage case with solution as recom-
mended by the lens case manufacturer or the e yecare practitioner; then allow the lens case to air dry. When
the case is used again, refill it with storage solution.Replace lens case at regular intervals as recommended
by the lens case manufacturer or the eyecare practitioner.
• Eyecare practitioners may recommend a lubricating/rewetting solution which can be used to wet (lubricate)
lenses while they are being worn to make them more comfortable.
• Eyecare practitioners may recommend a weekly enzymatic cleaner which can be used to effectively remove
protein deposits from rigid gas permeable contact lenses.
• BOSTON® MultiVision (enflufocon A) Contact Lenses cannot be heat (thermally) disinfected.
CARE FOR A STICKING (NONMOVING) LENS
If the lens sticks (stops moving/cannot be removed), the patient should be instructed to apply one to three drops
of a recommended lubricating or re wetting solution directly to the e ye and wait until the lens begins to move
freely on the eye before removing it.If nonmovement of the lens continues after 5 minutes, the patient should
immediately consult the eyecare practitioner.
REPORTING OF ADVERSE REACTIONS
All serious adverse reactions obser ved in patients wearing BOSTON ES® (enflufocon)Contact Lenses or
adverse experiences with the lenses should be reported to:
Consumer Affairs
Polymer Technology
Division of Wilmington Partners L.P.
1400 North Goodman Street
Rochester, NY 14692
1-800-333-4730
HOW SUPPLIED
Each lens is supplied (non-sterile) in a plastic lens storage case. The case is labeled with the base curve,
diopter power, diameter, center thickness, color, UV-absorber and lot number.