Baumfolder Flexifold: 2st Station (in 2004) User Manual

Page 3

PAGE 3

TP10495

TABLE OF CONTENTS

FUNDAMENTAL SAFETY INSTRUCTIONS ................................................................................5

1.0 INTRODUCTION........................................................................................................................21

2.0 SPECIFICATIONS......................................................................................................................21

3.0 INSTALLATION..........................................................................................................................21

3.1 Unpacking & Inspection ................................................................................................................21

4.0 ASSEMBLY .................................................................................................................................22

4.1 Main Unit .....................................................................................................................................22

4.2 Transfer Table ...............................................................................................................................22

4.3 Delivery Table ..............................................................................................................................22

4.4 Cross Carrier Assembly Installation .............................................................................................22

4.5 Fold Plate Installation ...................................................................................................................22

5.0 ELECTRICAL ACCESS ............................................................................................................23

6.0 OPERATION ...............................................................................................................................23

6.1 The Main Power/Reset Switch .....................................................................................................23

6.2 Starting the Production Job ..........................................................................................................23

6.3 Check Squareness of Fold ............................................................................................................23

6.4 Use Of Handwheel .......................................................................................................................24

7.0 OPERATOR PANEL ..................................................................................................................24

7.1 Button Identiﬁcation (2nd Function) ............................................................................................24

8.0 START UP ....................................................................................................................................25

9.0 SETUP ...........................................................................................................................................25

9.1 Setup for a Standard Fold ..............................................................................................................25

9.2 Setting Up a Special Fold ..............................................................................................................27

9.2.1 To Save a Non-Standard Fold in a Memory Location ................................................................27

9.2.2 Recall a Fold Saved in Memory Location ..................................................................................27

9.3 Starting the Production ..................................................................................................................27