Baumfolder BaumCut 26.4 (For serials 78D1001 thru 78D1100) - Manual (Page 100)

Basic information about servicing and maintenance work
• Always turn off the machine and disconnect the power supply before • In the event of defective safety equipment, e.g. safety light barriers,
undertaking any maintenance work. protective covers, etc., the machine/system must be taken out of
operation and repaired immediately.
Warning!
• All safety signs on the machine/system must be in impeccable and
All cables designated , and all cables with orange cladding will easily identifiable condition. Replace safety signs if this is not the
remain live even after turning off at the main switch!
case.
• Proceed as follows if maintenance work necessitates stepping onto
• Once the plant is turned off, prevent it from being turned back on
individual system components, e.g. lubrication of gripper
again by blocking the relevant main switch. If necessary, warning
components on the
signs should also be put up at the main switches to alert others to
cutting machine rear table or conveyor lines:
maintenance work in progress.
Before stepping onto conveyor units, pallets or cutting machine rear
table:
• Due to the need for special tools, we recommend that maintenance
Cover surfaces to be stepped on with cardboard and secure
and lubrication work be carried out by the POLAR After-Sales Ser-
cardboard in place with adhesive tape.
vice.
Warning! Slippery underfooting: Risk of slipping!
After finishing the works:
Totally remove cardboard and adhesive tape as well as any remains
• The product recommendations contained in these operating
of adhesive tape from the surfaces.
instructions, e.g. for oils and greases, may be regarded as up-to-date
at the time of going to press.
• For lubrication dismantle any guards at the guide units. Assemble
We cannot guarantee either the correctness or completeness of
the guards immediately after the maintenance work has been
these instructions. The user is responsible for ensuring compliance
performed (Safety!).
with all the applicable laws and regulations before using these
products. To ensure this, the relevant technical and safety data
• After lubrication:
sheets should be obtained from the appropriate manufacturers
Use a rag to remove any excessive lubricant (greases, oils)
before use. The user is advised to meet his obligations in respect of
completely which seeps out, especially above the table surfaces that
product observation, and to exercise due care when using the
contact the material to be cut.
products.
Polar will not be held responsible for any kind of damage or injury
• The specified maintenance intervals are based on an operating time
due to failure to comply with the descriptions provided by the
of 8 hours / day. For multi-shift operation the maintanance intervals
various manufacturers, or due to the risks associated with the nature
need to be adapted correspondingly.
of the product
• Compliance must be assured with the legislation on electrical plants
or systems, hydraulic and/or pneumatic equipment as applicable in
the country of use.
K8 - 2