Baumfolder BAUM20: Control Panel - Manual (Page 5)

TP10386 © Page 5 of 12
4
. Look to the right hand end of the counter display. If an “ 1 “ appears in the
display the Easy-Parameter is turned on. If an “ 0 “ is displayed, the Easy-
Parameter is turned off, see Figure E1.
To turn the Easy-Parameter on or off, Press the Plus (+) button
for the batch time delay setup. Pressing this button changes the “ 1 “ to an “ 0
“ and back. This button is found at the far right side of the top row, see Figure E1.
5.
Press the Machine Setup button again in the top row to confirm
and exit programming mode.
SELECT EASY MODE
Pressing this button enables the selection of either the EASY mode or cYcL
mode
Pressing these buttons will toggle between the EASY mode or cYcL mode. Set
EASY in the large display. You will notice that the sheet gap display screen has
(3) dashes when the Easy Mode is on and a number when it is off.
Press the mode selection button again to exit mode selection.
+
+