Resetting the total counter, Resetting the batch counter, Turn off batch counting – Baumfolder BAUM20: Control Panel User Manual
Page 12
TP10386
©
Page 12 of 12
and Stop Feeding.
RESETTING THE TOTAL COUNTER
To reset the Total Counter, Press Button
; ensure the red LED is
illuminated.
Press Button
and HOLD DOWN for 3 SECONDS,
The Large 8 digit display will begin to Count BACKWARDS from 5.4.3.2.1,
then display CLEARED, the Counter is then ZERO.
You MUST Press and HOLD Button
as the display is counting
BACKWARDS, if at anytime the
ZERO Button is released, the Counter
will display the Last Count Value
NOTE
The Batch counter will also be reset to 0 by this procedure.
RESETTING THE BATCH COUNTER
Press the Batch counter Button
; ensure the red LED is illuminated.
Press Button
and HOLD DOWN for 3 SECONDS,
The Large 8 digit display will begin to Count BACKWARDS from 5.4.3.2.1,
then display CLEARED, the Counter is then ZERO.
NOTE
The Total counter will not be reset to zero.
TURN OFF BATCH COUNTING:
Press the
counter setup button
and set either the batch size or time dwell
to zero.
Exit the counter setup mode by pressing the counter setup button again or any
button in the second row.