Bang & Olufsen BeoSound 5 Encore - Getting Started User Manual
Page 20

This product is in
conformity with the
provisions of the Directive
1999/5/EC (R&TTE).
AT, BE, BG, CH, CY, CZ, DE, DK, EE, ES, FI, FR, GB,
GR, HU, IE, IS, IT, LI, LT, LU, LV, MT, NL, NO, PL, PT,
RO, SE, SI, SK, TR.
Hereby, Bang & Olufsen declares that this Audio
System with WLAN is in compliance with the
essential requirements and other relevant
provisions of Directive 1999/5/EC.
The Declaration of Conformity may be consulted
at www.bang-olufsen.com/guides.
This product incorporates copyright protection
technology that is protected by U.S. patents and
other intellectual property rights. Use of this
copy right protection technology must be
authorized by Rovi, and is intended for home and
other limited viewing uses only unless otherwise
authorized by Rovi. Reverse engineering or
disassembly is prohibited.
HDMI, the HDMI logo and High-Definition
Multi media Interface are trademarks or registered
trade marks of HDMI Licensing LLC.
The distance from the human hand to the
transmitter antenna during normal use of this
product will be at least 6 cm, which is more than
the RF exposure safety distance of 4 cm.
Bang & Olufsen cannot vouch for the quality of
net radio stations available from programme
providers.
For the US-market only!
Changes or modifications not expressly approved
by the party responsible for compliance could void
the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
NOTE: This equipment has been tested and found
to comply with the limits for a class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harm ful inter ference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or tele vision
reception, which can be determined by turning
the equip ment off and on, the user is encouraged
to try to correct the interference by one or more
of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment
and receiver.
– Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
– Consult the retailer or an experienced radio/TV
technician for help.
For the Canadian market only!
This class B digital apparatus meets all requirements
of the Canadian Interference-Causing Equipment
Regulations.
This device complies with Industry Canada
licenceexempt RSS standard(s). Operation is
subject to the following two conditions: (1) this
device may not cause interference, and (2) this
device must accept any interference, including
interference that may cause undesired operation
of the device.
Under Industry Canada regulations, this radio
transmitter may only operate using an antenna of
a type and maximum (or lesser) gain approved for
the transmitter by Industry Canada. To reduce
potential radio interference to other users, the
antenna type and its gain should be so chosen
that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for
successful communication.
This radio transmitter (3775A-SMALLENGINE) has
been approved by Industry Canada to operate
with the antenna types listed below with the
maximum permissible gain and required antenna
impedance for each antenna type indicated. Antenna
types not included in this list, having a gain greater
than the maximum gain indicated for that type,
are strictly prohibited for use with this device:
Tyco Electronics Antenna 1551359-1, Gain 5dBi,
Impedance 50 Ohm.
This equipment complies with IC RSS-102 radiation
exposure limits set forth for an uncontrolled
environment. This equipment should be installed
and operated with a minimum distance 20 cm
between the radiator and your body.
Please note that high-power radars are allocated
as primary users (i.e. priority users) of the bands
5250-5350 MHz and 5650-5850 MHz and these
radars can cause interference and/or damage to LE-
LAN (License-exempt Local Area Network) devices.
20