Bang & Olufsen BeoSound 5 Encore - Getting Started - Manual (Page 14)

Set up your music system
Light partition walls If you intend to hang the music system on a gypsum wall (also known as dry wall or wall board), the wall
bracket must be fastened to a vertical stud. Use one lag screw (5 mm – 0.2"), which penetrates the
gypsum, and is screwed a minimum of 25 mm (1") into a vertical stud. For stability, use two additional
screws of a type intended for gypsum walls. Mounting was evaluated for use on a drywall surface.
Information
The music system must be placed on a wall, or on one of the optional accessories.
Follow the instructions below to place the music system on a wall – using the
standard wall bracket.
Place the wall bracket
Fasten the wall bracket
Use the appropriate size and type of screws and
wall plugs – taking into account the construction
and condition of the wall. Use three screws/
fasteners with a minimum load rating of 3.5 kg
(8 lbs.).
Before you fasten the music system on the wall
bracket, insert the cables into the corresponding
sockets of the cylinder on the back of the music
system (B). For information about sockets, refer to
page 16.
Find the correct place for the music system.
Use the enclosed wall bracket and spacer as a
template to mark up where to drill the holes.
To make sure the wall bracket is level, place a spirit
level on top of the two designated supports (A).
80 mm
3.15"
140 mm
5.5"
260 mm – 10.24"
A
B
14