beautypg.com

Set up the loudspeaker – Bang & Olufsen BeoLab 7-6 - User Guide User Manual

Page 4

background image

Set up the loudspeaker

We recommend that you follow

this procedure:

– Disconnect your Bang & Olufsen

system from the mains supply.

– Fasten the loudspeaker as

explained on the next page.

– Connect the loudspeaker and set

the position switch as explained

in ‘Cable connections’ (pp. 6–7).

– Connect the entire system to the

mains again.

Cautions!

– Make sure that the loudspeaker

is placed and connected in
accordance with the instructions
in this Guide. To prevent injury,
use Bang & Olufsen approved
stands and wall brackets only!

– The loudspeaker can only be

switched off completely by
disconnecting it from the wall
socket.

– Do not attempt to open the loud-

speaker. Leave such operations

to qualified service personnel!

– The loudspeaker is designed for

indoor use in dry, domestic
environments only, and for use
within a temperature range of

10–40º C (50–105º F).

– Always place the loudspeaker in

a horizontal position, and do not
place any items on it.

– In order not to block the sound

emitting from the rear bass
reflex ports and the bass units
on the bottom, leave a minimum
of 6 cm (2½”) free space behind
and below the loud speaker.

Prolonged listening at high

volume levels may cause hearing
damage!

Handling the loudspeaker: In
order not to dent or scratch the
loud speaker front grill, we
recommend that you lift the loud­
speaker by holding on to the two

bass units on the bottom. Do not
support the loud speaker holding

the loud speaker front grill!

4