Bang & Olufsen BeoLab 4 - User Guide - Manual (Page 4)

Set up the loudspeakers
We recommend that you follow
this procedure:
– Disconnect your system from the
mains.
– Connect the loud speakers and set
the LINE IN–POWER LINK switch
on each loud speaker as explained
in ‘Cable connections’ (pp. 6–7).
– Set the POSITION switch to the
correct setting on each loud-
speaker. This is explained in ‘Adapt
the loud speaker to your room’
(pp. 8–10).
– Connect the entire system to the
mains again.
The loud speaker must be placed
standing upright on its base, or
fastened to one of the optional
accessories. Make the connections,
and set both switches before you
fasten the loud speaker to one of the
accessories.
Cautions
– Make sure that the loud speakers
are placed and connected in
accordance with the instructions
in this Guide. To prevent injury,
use Bang & Olufsen approved
stands and wall brackets only!
– The loudspeaker can only be
switched off completely by
disconnecting it from the wall
socket.
– Do not attempt to open the loud-
speaker. Leave such operations to
qualifi ed service personnel! The
speaker panels, how ever, may be
removed for cleaning.
– The loud speaker is designed for
indoor use in dry, domestic
environments only, and for use
within a temperature range of
10–40º C (50–105º F).
– For optimum sound quality, do not
place the loud speaker enclosed in,
for example, a small book case.
Leave a minimum of 20 cm (8")
free space at the sides, and never
place anything directly in front of
the loud speaker.
– Do not block the sound emitting
from the bass refl ex port at the
bottom of the loud speaker.
– Place the loudspeaker with its
front (the Bang & Olufsen name
plate) facing your favourite
listening position.
4