Bang & Olufsen BeoLab 4 - User Guide - Manual (Page 10)

>> Adapt the loudspeaker to your room 10
Example 2: This illustration shows
the position zones projected onto
the ceiling. The loud speakers – on
ceiling brackets – are placed within
position zone 2 (darker grey zones),
and therefore the POSITION switch
should be set to 2 on both loud-
speakers.
If you have a BeoLab 2 sub-
woofer setup …
As explained in the BeoLab 2
Guide, the sub woofer has a SETUP
switch which can be set to 1, 2,
or 3. This will adapt the out put
from BeoLab 2 to the sensitivity
levels of different loud speakers.
If you connect a pair of BeoLab 4
loud speakers to the BeoLab 2 sub-
woofer, we recommend that you
set the BeoLab 2 SETUP switch
to position 2.