Bang & Olufsen BeoLab 1 - User Guide - Manual (Page 4)

4
How to set up the BeoLab 1 loudspeaker
We recommend that you follow this
procedure when setting up the
BeoLab 1 loudspeaker:
1 Finish unpacking and assemble
the column and base plate as
described on page 5.
2 Disconnect your Bang & Olufsen
system from the mains.
3 Connect your loudspeaker as
described on pages 6–7.
4 Set the L • R • LINE switch and
the Speaker Position switch to
the correct setting on each
BeoLab 1 as described on pages
8–9.
5 Lift the assembled BeoLab 1 off
the packing materials, and place
it. As for the placement of each
speaker, please refer to pages
8–9.
6 Connect both loudspeakers (and
your system) to the mains – and
enjoy!
Before you start…
Here we have a list of things which should
be considered before setting up the
BeoLab 1:
• Make sure that the BeoLab 1 is set up
(placed and connected) in accordance with the
instructions in this Guide.
• Always place your BeoLab 1 on a firm and
stable surface.
• The BeoLab 1 is designed for indoor use in
dry, domestic environments only, and for use
within a temperature range of 10–40 ° C (50–
105 ° F).
• Remember that all speakers in a setup need a
connection to a mains outlet, and that they, in
order to switch on automatically, are designed
to be connected to the mains at all times.
• Do not turn the power on for any units in
your system, until after you have all the cables
plugged in (pages 6–7).
• On the top of the BeoLab 1 is a small recess.
This is for ventilation of the powerful BeoLab 1
amplifiers. Do not cover up this recess (and do
not use it as ‘a carrying handle’ when moving
your BeoLab 1 loudspeaker).
• Do not attempt to open your BeoLab 1.
Leave such operations to qualified service
personnel.
Bottom view of the BeoLab 1 showing access
to the panel with the sockets and switches.
The use and purpose of the sockets and
switches is described on pages 7–9.