Bang & Olufsen BeoVision MX_8000 - User Guide - Manual (Page 16)

16
The rear socket panels on BeoVision
MX 8000 allow you to connect the
signal input cables as well as a
variety of extra equipment.
The V.TAPE and AV sockets are
available for connection of extra
equipment.
Any equipment you choose to
connect to these sockets must be
registered in the BeoVision MX 8000
CONNECTIONS menu. Refer to
BeoVision MX 8000 CD-rom and the
chapter Register extra equipment for
further instruction.
The presence or absence of the
sockets depends on which optional
extras are built into your BeoVision
MX 8000.
Socket panel on the rear
Speaker and digital input socket panel
These sockets are only available if your BeoVision
MX 8000 has a built-in digital surround sound
module.
Refer to the BeoVision MX 8000 CD-rom and the
chapter Loudspeaker setup – surround sound for
further information.
STAND
For connection of a motorised stand.
AV
21-pin socket for AV connection of a second
decoder, a DVD player, a set-top box or similar
devices. You can also connect other types of
auxiliary equipment or an Expander box for further
connections.
V.TAPE
21-pin socket for the AV connection of a BeoCord
V 8000 video tape recorder, a set-top box, a
primary decoder or another video tape recorder.
You can also connect other types of auxiliary
equipment to the V.TAPE socket. If the connected
video tape recorder is a BeoCord V 8000, the
tuned TV programs etc. will be downloaded to the
video tape recorder when the BeoVision MX 8000
TV is tuned in.
MASTER LINK
For connection of a compatible Bang & Olufsen
audio system. This socket is only available if your
BeoVision MX 8000 is equipped with the
Master Link module.
The socket is also used for BeoLink distribution of
sound and picture throughout the house.
LINK TV
Aerial output socket for distribution of video
signals to other rooms. This socket is only available
if your BeoVision MX 8000 is equipped with the
built-in system modulator.
TV
Aerial input socket for your external TV aerial (or
cable TV network) signal. If your BeoVision
MX 8000 is equipped with the built-in system
modulator, connect your external TV aerial to the
TV socket located below the socket marked LINK.
POWER LINK
For connection of external Bang & Olufsen
loudspeakers.
~
Socket for connection to the mains.
IR OUT
For connection of a set-top box. (Only available
when a Set-top Box Controller is built into your
BeoVision MX 8000).
STAND
V. TAPE
MASTER LINK
POWER LINK TV
LINK TV
IR-OUT
AV
SUBWOOFER
FRONT REAR
FRONT REAR
INPUT 1 INPUT 2