Bang & Olufsen DVB-S - User Guide - Manual (Page 16)

Bring up the satellite Setup menu >Installation >Edit Satellite
Settings.
Select an empty position and enter the necessary information as
described in the menu, then do a Program Search on this new
satellite.
Bring up the satellite Setup menu >Installation >LNB/Aerial
Setup.
Enter the necessary information as described in the menu, and
do a Program Search to fi nd new, available programs. Note that
only universal LNBs are supported.
Switch your television to standby and wait until the standby
indicator turns red, then switch on again.
If the problem persist, disconnect your system from the mains
and check connections, then reconnect to the mains.
If this does not solve the problem, contact your Bang & Olufsen
retailer.
If the module is set up for automatic reception of digital audio
and the programme is broadcast without digital audio, there is
no sound in the speakers.
Bring up the satellite Setup menu >Preference >Digital audio.
Change the setting from ‘Automatic’ to ‘Manual’. You can still
change to digital audio when watching a program transmitted
with digital audio (this can be seen from the icon at the top
of the Information display).
If… Then…
You wish to add a satellite to the
already preset, available
satellites…
You wish to add a new LNB to
your setup…
There is no picture when you
switch to satellite or the system
seems to ‘lock’ on one channel…
There is no sound while watching
a programme…
16