Belkin F5D5630AU - Manual (Page 17)

30
Manually Configuring your Modem-Router Manually Configuring your Modem-Router
31
se
ct
io
n
2
1
3
4
5
6
7
Click Add or Edit to
display the following page
and add a new static route
to the list.
Parameter Description
Index Displays the number of the route.
Network
Address Enter the IP address of the remote computer for
which to set a static route.
Subnet Mask Enter the subnet mask of the remote network for
which to set a static route.
Gateway Enter the WAN IP address of the gateway to the
remote network.
RIP Parameter
The device supports
Routing Information
Protocol (RIP) v1 and v2
to dynamically exchange
routing information with
adjacent Modem-Routers.
Description
RIP mode Globally enables or disables RIP.
Auto summary If Auto summary is disabled, then RIP packets will
include sub-network information from all sub¬net
works connected to the ADSL Modem-Router.
If enabled, this sub-network information will be
summarized to one piece of information covering
all sub-networks.
Interface The WAN interface to be configured.
Operation
Mode Disable: RIP disabled on this interface.
Enable: RIP enabled on this interface.
Silent: Listens for route broadcasts and updates
its route table. It does not participate in sending
route broadcasts.
Version Sets the RIP version to use on this interface.
Poison Reverse A method for preventing loops that would cause
endless retransmission of data traffic.