Bang & Olufsen BeoVision Avant Real Flat Version (1995-2005) - User Guide - Manual (Page 6)

6
The operations shown on this page
are functions you will use daily:
– Choose a TV or Satellite channel
by its number;
– Switch to another channel or
source;
– Call a channel list up on the
screen;
– Adjust the position of the TV on
its motorised stand;
– Adjust the sound volume.
All of these functions can be
performed via the Beo4 remote
control, though you can also adjust
TV position by hand.
Watch television
Select a TV or Satellite* channel
To watch a TV or Satellite channel, press the
appropriate button on Beo4. BeoVision Avant
switches on the last channel you watched.
See a channel list
All your TV and Satellite channels appear on
separate lists, which you can call up on the
screen. The lists contain channel numbers and
names. The lists can contain 99 TV channels
and 119 Satellite channels.
*NOTE! Satellite channels are only available if your
BeoVision Avant is equipped with the built-in
Satellite receiver module.
Press TV or SAT to switch on
the source. The last channel
viewed appears on the screen
Press a channel number to go
directly to that channel
Press ▲ or ▼ to change
channels one by one
Press another source button at
any time to change to that
source
Press to switch off BeoVision
Avant
TV
TV 2
0 – 9
▲
▼
SAT
•
While BeoVision Avant is off... Press TV or SAT to switch on a
source
Press and hold GO to call up a
channel list on the screen
Press ss or tt to view the
previous or following page of
the channel list
To select a channel to watch,
press the channel number on
Beo4 or press ▲ or ▼ until the
cursor is on the desired channel
To switch on the chosen
channel, press GO, or press
EXIT to leave the menu
TV
GO
ss tt
0 – 9
▲
▼
GO
EXIT
You can also call up the channel list by pressing
MENU to call up the main menu, and then
pressing either 3 or 4 to select the appropriate TV
or Satellite list.