BBE DS48 - Manual (Page 12)

6
INSTALLATION
®
Your DS48 was carefully packed at the factory and the packaging was
designed to protect the unit from rough handling. Nevertheless, we recom-
mend that you carefully examine the packaging and its contents for any
signs of physical damage that may have occurred in transit.
6.1 RACK MOUNTING
The DS48 fits into one standard 19” rack unit of space. Please allow at least an addition-
al 4” depth for the connectors on the back panel. Though this device does not generate
significant heat, be sure that there is enough air space around the unit for cooling. To
avoid overheating, do not place the DS48 in rack above devices that generate significant
heat such as power amplifiers.
6.2 CONNECTORS
The DS48 must be installed using standard 3 –pin type XLR jacks. Although the inputs are
fully balanced, the automatic servo-functions allow them to operate with unbalanced
source/loads. Audio outputs also use XLR jacks.
PIN 1 = Ground
PIN 2 = HOT (+)
PIN 3 = COLD (-)