BBE DS48 - Manual (Page 11)

5
QUICK START
Depending on the mode selected, other options will appear for this level of the menu, primarily
concerned with input and output assignments. Some assignments are fixed with the crossover
type selected. Only those assignments that can be selected will show on the display. Either the
BACK/NEXT (2) buttons or the Parameter dial will work for stepping through the selections.
10. Press GAIN (4). Set the gain for Input A with gain knob (9).
Press NEXT (2) and set the gain for Input B with gain knob (9).
Repeat procedure to set gain for outputs C & D.
Gain value is selected with the GAIN knob (9).
After setting all gains, press NEXT (2) again.
11. You are now in the Output programming section. Depending on the configuration selected, the different out-
puts will show in the upper left corner of the display as OP1, OP2, etc. You can select an output and then
step through the parameters of with the BACK/NEXT (2) buttons OR use the GAIN (4) button to step through
the outputs, changing the same parameter for each output as it is displayed and cycle through the outputs
for each parameter.
12. In the PEQ screen, the ENTER (6) button is used to toggle between
PEQ “
✧
” ,
Low Shelf “}” ,
Hi Shelf “{“ , and
Bypass “=”
13. After completion of the patching and programming, power up the rest of the system and enjoy improved
sound quality.
14. Practice “safe sound”.
ᕋ
10 11
12