Antelope Audio Trinity Master Clock - Manual (Page 13)

Appendix C
Display says:
Read:
Solution 1
Solution 2
Display says:
Read:
Solution 1
Solution 2
Solution 3
Display says:
Read
Solution 1
Solution 2
Error Messages
CANNOt dA CHOSEN SOUГCE
Cannot DA Chosen Source
Continue in DA mode by changing SOURCE knob to a position corresponding to a valid rear panel input.
Leave DA mode, selecting an internal sample rate.
NO IПPUt
No Input
Continue in DA mode by applying a valid rear panel input that corresponds to the front panel SOURCE
knob.
Continue in DA mode by changing SOURCE knob to a position where there is a valid rear panel input.
Leave DA mode, selecting a standard sample rate.
SOURCE OFF-ГAtE
: Source Off-Rate
Continue with the off-rate input, and select SPLIT mode. The audio channel must also be in DA mode.
Change SOURCE knob to OVEN and run on internal clock.
Reason:
Reason:
Reason:
The Audio channel is set to DA, and SOURCE is set to either OVEN or VIDEO.
The Audio channel is set to DA, but there is no input on the chosen SOURCE.
Input is a non-standard frequency that is not one of the recognized gearboxing frequencies
as in Appendix A , and is likely a varispeed input frequency. on page 11
12