AJA Hi5-3G - Manual (Page 7)

1
7 AJA Hi5-3G 3G/HD/SD-SDI to HDMI 1.3a Video and Audio Converter
Mini Config, Video Screen
The name of each Mini-Converter found can be seen in the menu pulldown at the top
right hand side of the screen (in the example above, it shows “Port: 0 (HI5-3G)”. This
allows you to select a desired Mini-Converter when there are more than one. Selecting
a Mini-Converter with this dropdown menu causes this application to connect to the
selected converter. The type of Mini-Converter and serial number will be shown in the
graphic and text below it.
A status field at the bottom of the screen shows whether you are connected and
communicating with the Mini-Converter shown using Mini-Config.
When configuring the Hi5-3G Mini-Converter, select it from the top pulldown, view the
current settings and change any values. Making a change communicates that new
value to the Mini-Converter’s non-volatile memory.
Tabbed Screens The Tabs delineate groups of controls for each type of task to be performed.
Mini Config, Tabbed Screens
The controls for the actual configuration parameters are specific to each Mini-
Converter type. Click on any of the tabbed buttons (Input/Output/Update/Info) and the
screen below will change to match. Each of these screens are described on the
following pages.
Tabbed screens
Message
Showing Status
Each connector
is labelled with
the signals
currently detected
or manually
selected.
Blue = Auto
Black = Manual
selection
Select a USB
port and
an attached
Mini-Converter
(name in parentheses)
Red = No Signal or
signal output
since device not
detected
Firmware version
Tabbed screens