beautypg.com

Pre-cut locator, Using the table pointer when table is extended – Bosch 4100DG User Manual

Page 60

background image

60.

Pre-Cut Locator

Allows you to mark and locate exactly where the blade will enter
the workpiece.

Always make sure table saw is turned off and unplugged.

Set blade

1 at 90 degrees square to table. Using a straight edge

and a soft pencil, place straight edge

2 against both sides of

blade and mark lines on locator

3 (Fig. 47). These lines indicate

the “path” of the cut (kerf) made by the blade.

When cutting the workpiece, line up mark on workpiece with the
line on the disc (Fig. 48).

90

30

45

60

75

75

60

45

30

FIG. 47

FIG. 48

Using The Rip Fence Pointer

When Table Is Not Extended

The rip fence pointer shows the distance from the blade to rip fence
through a convenient viewing and magnifying window.

Align rip fence pointer

4 with lower portion of scale 5. The lower

scale can be used for widths up to 13.5 inches (Fig. 49).

Using The Table Pointer

When Table Is Extended

The upper portion of scale

6 is used for rip cut 13.5 to 25 inches.

Align table pointer

7 with upper portion of scale 6 (Fig. 49).

Making Rip Cuts Beyond 25

Inches Without The Use Of Scale

When positioning fence for maximum rip without the use of scale,
loosen screw

8 and lower plate 9 below the head 10 of the rip

fence

11 (Fig. 49). DO NOT rip or cut dados or moldings with the

fence beyond this position because it cannot be locked.

FIG. 49

1

3

2

4

5

6

7

8

9

10

11