Installation – AJA GEN10 User Manual
Page 6
GEN10 Mini-Converter v1.0r2
www.aja.com
6
Installation
Typically, GEN10 installation consists of the following:
1. Disconnect +5VDC from the converter.
2. If you wish to operate the GEN10 in NTSC without Setup (no offset), open the case
and set the internal jumper as required.
3. Configure the DIP switches for the desired sync generator formats.
4. Connect external devices to the converter BNCs.
5. Apply power to the converter.
See also other documents in the category AJA Accessories for video:
- Ki Pro (110 pages)
- Ki Pro (16 pages)
- Ki Pro Rack (111 pages)
- Pak Dock (8 pages)
- CamXchange (16 pages)
- FS1-X Manual (137 pages)
- FS1-X Quick Start (10 pages)
- FS1 Version 2.2.0.47 (138 pages)
- FS1 Version 2.2.2.1 (140 pages)
- FS2 Manual (125 pages)
- FS2 Manual (230 pages)
- FS2 Quick Start (14 pages)
- KUMO (66 pages)
- LUT-box (34 pages)
- Hi5-Plus Version 1.0 (27 pages)
- HA5-Plus Version 1.3 (28 pages)
- 4K2HD (32 pages)
- HD10A-Plus (18 pages)
- V2Analog (27 pages)
- V2Digital (26 pages)
- ROI (36 pages)
- UDC (29 pages)
- ADA4 (22 pages)
- 3GM (19 pages)
- 3GDA (13 pages)
- HA5 (18 pages)
- Hi5 (19 pages)
- Hi5-Fiber (6 pages)
- Hi5-3G (18 pages)
- HD10AVA (8 pages)
- HD10CEA (8 pages)
- HD10C2 (20 pages)
- HD10MD3 (21 pages)
- HD10AM (24 pages)
- HD10AMA (24 pages)
- HDP2 (20 pages)
- FiDO (18 pages)
- D5PSW (4 pages)
- D4E (6 pages)
- D10CEA (8 pages)
- T-TAP (43 pages)
- Ki Pro Mini (106 pages)
- Ki Pro Mini (10 pages)
- KONA LHi Capture Card (12 pages)